Components for Elevators

Elevator belt 4-layer, 630 N/mm, with wear-resistant covering layers type W

Elevator belt 4-layer, 630 N/mm, oil and grease resistant

Elevator belt 5-layer, 800 N/mm, with wear-resistant covering layers type W

Elevator belt 5-layer, 800 N/mm, oil and grease resistant

Elevator belt 5-layer, 800 N/mm, highly heat-resistant

Elevator belt 5-layer, 1000 N/mm, heat-resistant

An overview of our elevator belt connectors, which are adapted to the high weight that a vertical elevator belt carries.

Elevator bolts have special pins that pull into the belt and ensure that the cup can be pressed tightly against the belt.

One of the most commonly used elevator buckets, with a low back. This allows many cups to be placed per meter. Available in steel, stainless steel and plastic

The Columbus elevator bucket is a pressed steel or plastic bucket based on DIN15232. These elevator buckets are available in normal steel, stainless steel and plastic (HDPE / Nylon).

The sheet steel elevator buckets can be ordered in deep or shallow version. Completely according to DIN 15231, 15232, 15233 and 15234.

The Atlas industrial elevator buckets, injected in a mold, are made of a very tough and wear-resistant nylon.

The monocast elevator buckets are cast from nylon with an addition of molybdenum disulfide. The deep elevator bucket is extremely suitable for lifting glass, glass shards, cement, sand and other products subject to wear.